| 摘要: |
| 利用高温高压釜模拟CO2辅助蒸汽驱注气井筒工况,在CO2分压为2 MPa,温度为160～220 ℃条件下,对低合金钢进行了失重挂片腐蚀试验,得到了不同温度条件下管材的腐蚀速率,并利用扫描电镜和能谱仪观测管材在不同温度条件下的腐蚀形貌及产物组成。实验结果表明:在160～220 ℃范围内,随着温度的升高,低合金钢的腐蚀速率呈现先降低后增大的变化趋势,且均在160 ℃时腐蚀速率最高；在实验条件下,两种低合金碳钢的均匀腐蚀速率均小于油田控制指标0.076mm/a,满足注气井井筒管柱的腐蚀控制要求。 |
| 关键词: 蒸汽驱 CO2腐蚀 温度 油套管钢 腐蚀速率 |
| DOI：10.3969/j.issn.1007-3426.2017.04.015 |
| 分类号: |
| 基金项目: |
|
| Evaluation of corrosion resistance for low alloy steels in high temperature steam environment with CO2 |
|
Wu Yuanyue1, Shi Shanzhi1, Huang Jianbo1, Yu Huiyong1, Dong Baojun2, Zeng Dezhi2
|
|
1. Research Institute of Engineering Technology, PetroChina Xinjiang Oilfield Company, Karamay, Xinjiang, China;2. State Key Laboratory of Oil & Gas Reservoir Geology and Exploitation (Southwest Petroleum University), Chengdu, Sichuan, China
|
| Abstract: |
| By simulating the environment of CO2 auxiliary steam with HTHP autoclave, the corrosion behavior of low alloy steels was studied under 160-220 ℃ and 2 MPa partial pressure, and the corrosion rate was measured by the weight loss method. The morphology and composition of the corrosion product under different temperature were analyzed by SEM and EDS. The results showed that the average corrosion rate of N80 and 3Cr steels appeared as a deep ‘V’ shape. The corrosion of N80 and 3Cr steel reached the maximum when the temperature was 160 ℃. Under the test conditions, the uniform corrosion rates of two low alloy steels were less than the control target of oil field (0.076 mm/a), and both met the demand of gas injection well. |
| Key words: steam drive CO2 corrosion temperature well tube steel corrosion rate |
